PIC12F675 8DIP

High-Performance RISC CPU:

• Only 35 Instructions to Learn
– All single-cycle instructions except branches
• Operating Speed:
– DC – 20 MHz oscillator/clock input
– DC – 200 ns instruction cycle
• Interrupt Capability
• 8-Level Deep Hardware Stack
• Direct, Indirect, and Relative Addressing modes

Special Microcontroller Features:

• Internal and External Oscillator Options
– Precision Internal 4 MHz oscillator factory calibrated to ±1%
– External Oscillator support for crystals and resonators
-5 us wake-up from Sleep, 3.‎0V, typical
• Power-Saving Sleep mode
• Wide Operating Voltage Range – 2.‎0V to 5.‎5V
• Industrial and Extended Temperature Range
• Low-Power Power-on Reset ‪(POR)‬
• Power-up Timer (PWRT) and Oscillator Start-up Timer ‪(OST)‬
• Brown-out Detect ‪(BOD)‬
• Watchdog Timer (WDT) with Independent Oscillator for Reliable Operation
• Multiplexed MCLR/Input Pin
• Interrupt-on-Pin Change
• Individual Programmable Weak Pull-ups
• Programmable Code Protection
• High Endurance Flash/EEPROM Cell
– 100,000 write Flash endurance
– 1,000,000 write EEPROM endurance
– Flash/Data EEPROM Retention: > 40 years

Low-Power Features:

• Standby Current:
– 1 nA @ 2.‎0V, typical
• Operating Current:
-8.5 uA @ 32 kHz, 2.‎0V, typical
-100 uA @ 1 MHz, 2.‎0V, typical
• Watchdog Timer Current
– 300 nA @ 2.‎0V, typical
• Timer1 Oscillator Current:
-4 uA @ 32 kHz, 2.‎0V, typical

Peripheral Features:

• 6 I/O Pins with Individual Direction Control
• High Current Sink/Source for Direct LED Drive
• Analog Comparator module with:
– One analog comparator
– Programmable on-chip comparator voltage reference (CVREF) module
– Programmable input multiplexing from device inputs
– Comparator output is externally accessible
• Analog-to-Digital Converter module ‪(PIC12F675)‬:
– 10-bit resolution
– Programmable 4-channel input
– Voltage reference input
• Timer0: 8-Bit Timer/Counter with 8-Bit Programmable Prescaler
• Enhanced Timer1:
– 16-bit timer/counter with prescaler
– External Gate Input mode
– Option to use OSC1 and OSC2 in LP mode as Timer1 oscillator, if INTOSC mode selected
• In-Circuit Serial ProgrammingTM (ICSPTM) via two pins